All projects

TrailersRails + expanded-metal deck

Utility trailer: rails and mesh before it rots through

Rusty rails and an expanded-metal deck, blasted clean in one afternoon with the tank rig.

Utility trailer

Time
One afternoon
Media
~6 bags
Media cost
~$140

Estimates for a job this size.

The problem

Rails and a mesh deck: hundreds of small openings and edges where rust starts. A wire wheel canโ€™t get into the mesh.

The setup

The tank on its stand beside the trailer: fill it once and keep going. A pressure washer from 1,800 PSI up, ground you can hose down.

How it ran

  1. Top rails, one side at a time
  2. The mesh deck, at an angle so the stream goes through
  3. Uprights and corners
  4. Under the deck and the tongue
  5. Rinse it down

The finish

Inhibitor in the last rinse, the mesh left to drain, AP1, then paint the same day.

What you need

  • A pressure washer from 1,800 PSI up
  • Ground you can hose down
  • Eyes, face and hands covered

Finish, in order

  1. RinseRust inhibitor in the last rinse
  2. DryLet the mesh drain
  3. TreatAP1 on the bare steel
  4. PaintThe same day

Gear for a job like this

The media and finish products for this kind of job.

Questions

Does it get into the mesh?

Yes. Hold the nozzle at an angle so the stream goes through the openings, not just across them.

Tank or gravity bag?

For a whole trailer, the tank. You fill it once and donโ€™t stop to swap bags.

How long before it rusts again?

Bare steel outdoors starts within hours. Inhibitor in the rinse, AP1, then paint the same day.

More projects

Not sure which setup? Call us.

Tell us your pressure washer and your project. We'll tell you exactly which setup and media to get, and what you don't need.

Lines openMonโ€“Fri ยท 9amโ€“6pm EST

Questions? Call us

(819) 410-4210 Compare the systems